How do I use Renderoc FC?

Apply the mixed Renderoc FC to the prepared substrate by steel trowel from a feather-edge up to 3mm thickness. It should be applied with the minimum of working and be allowed to partly set before finally trowelling to a smooth finish.

What is Renderoc used for?

Renderoc HB is a lightweight, high build concrete repair mortar for patching small sections in concrete up to 25 MPa. It can be applied to vertical concrete patches 10mm to 80mm deep.

What is Renderoc RG?

Renderoc RG is used for repairs to damaged reinforced concrete elements, particularly where access is restricted and where vibration of the placed material is difficult or impossible. It is suitable for various structural strengthening measures such as encasement build-ups, jacketing etc.

What is Renderoc plug?

Renderoc Plug are rapid setting mortars which are easy to apply to horizontal, vertical or overhead surfaces at a wide range of thicknesses. There are two grades available: Renderoc Plug 1 with an initial set time of approximately 1 minute, and Renderoc Plug 20 with an initial set time of approximately 20 minutes.

How do you mix Renderoc?

If mixing small quantities by hand, Renderoc FC should be volume-batched. Add three volumes of the Renderoc FC powder (loose-filled to excess and struck off level with the top of the measuring container) to one volume of drinking quality water. This should be mixed vigorously for a minimum of 3 minutes.

What is a fairing coat?

Fairing Coat is a single component polymer modified levelling material specially formulated to re-profile concrete in thin applications without cracking. USES. Fairing Coat is designed for application to concrete surfaces which are to receive a compatible protective coating.

What is Nitobond AR?

Nitobond AR is a modified acrylic emulsion which is specially designed for use as a bonding aid, curing agent and gauging liquid for cementitious systems. It is resistant to hydrolysis and can therefore be used for external application.

What is fosroc used for?

Used for all structural concrete where improved density and quality are required.

How is Nitobond used in concrete?

Nitobond SBR is a modified styrene butadiene rubber emulsion which is supplied as a ready to use white liquid. It is designed to improve the qualities of site-batched cementitious mortars and slurries. Being resistant to hydrolysis, it is ideal for internal and external applications in conjunction with cement.

What is GP2 cement?

Main uses. Conbextra GP2 is a blend of Portland cement, graded fillers and chemical additives which impart controlled expansion in the plastic state whilst minimising water demand. The low water demand ensures high early strength. The graded fi llers are designed to assist uniform mixing and produce a consistent grout.

How do I use Cebex 100?

The selected water content should be accurately measured into the mixer. Slowly add the cement (and sand if required) and Cebex 100. Mix continuously for 5 minutes, making sure that a smooth even consistency is obtained. Areas to be grouted should be prepared to ensure substrates are clean, sound, and then pre-wetted.