What does send return do on an amp?

They’re for an effects loop. the send and return is for the effects loop, if you jack a cord out of the send jack and through some pedals and then back to the return those pedals will work beneath the amps ordinare controls, you can also use the send jack to plug in a recording device as you said.

How do you use Send and Return on amp?

The FX loop sends the post amplified/equalized signal out of the amp (The SEND jack), and into a pedal of your choosing. That signal is then processed through the pedal and fed back into the amp before the Power Amp section of the amplifier (The RETURN jack).

How does send and return work?

What are sends and returns? Sends and Returns let you run multiple sounds through the same effect in your mix. No more putting a reverb on every different channel and trying to duplicate the settings knob-by-knob. Each Return channel in your DAW allows you to set up an effect on a separate channel.

How do you connect a looper pedal to an amp?

How to Connect your Pedals to your Guitar and Amp

Make sure your amp is turned off.
Connect your guitar cable to your guitar.
Then plug the other end into the “input” side of your pedal.
Plug another guitar cable into the “output” side of your pedal.
Then plug the other end into the “input” on your amp.

Can you ship a guitar amp?

When possible, ship in the hard case Use plain brown packing paper to fill empty spots between the electric guitar and its case to immobilize it during transit. The packing paper should fill the bottom, sides, and top of the case. If you don’t have packing paper on hand, newsprint or paper towels can do the trick.

Can you add an effects loop to an amp?

The short answer: Yes, but it’s not trivial, and it’s difficult to get it sounding good. The long and detailed answer: The main reason for having an FX loop in an amplifier is to add time-domain effects, such as delay, chorus and/or reverb.

Can you use a loop pedal with any amp?

Of course you can. It runs just like a normal pedal. You dont have to have an effects loop for anything. Some pedals sound better in the effects loop.

Is FX loop necessary?

An effects loop isn’t needed at all. It’s a great feature to have, but a looper is generally run through the front end anyway. Time based effects, ie. a delay are generally run through a loop if the amp is equiped with one.

Do you really need an effects loop?

You should use an effects loop if: You use the distortion on your amp if you want your delays and reverbs to be clearer than ever whilst using a distorted amp.

Where does looper go in pedal chain?

Normally, you’ll want the looper to be able to record and playback any of your sounds. Of course, this means you should place it at the very end of the chain so it can hear and record whatever pedal combinations you use.

How do you use the send on a tube amp?

From the back of the amp, you connect the send to the next set of effects you want, from which you connect their output to the return of the amp so the final sound is amplified. If you connect the send to the recordin input it will sound pretty crappy and thin.

How do I connect my amp to my effects pedal?

Connect the “Send” jack to the input of your effects pedal or processor, and the “Return” jack to the output of your effect or processor. If the amplifier has any send or return level controls, you will want to set these while playing your amplifier.

What does the return level control do on an amplifier?

Your return level control simply provides a signal back to the amp from your pedals or processors. This level control is not seen very much as the master control in most amplifiers takes care of this for you. But should you see it on an amplifier, it can assist with getting the right signal back to your amplifier.